When it is almost time for the second captioner to begin, she (the second captioner) should enter the provided Access Code. With iCap it is possible to perform an almost split-second switchover between captioners when necessary. How do I perform a timed-switchover with another captioner? Make sure that the BCS status window displays "Connected". At this point BCS should be capable of communicating with iCap. Select "EEG iCap", thn click the "Dial" button. In the Connection dialog you should see the "EEG iCap" profile that was previously configured. It will say "Not Connected".ĥ) In Case Catalyst go to the "Setup" menu and select "Connection". You can verify this by viewing the BCS status window. You must complete the next step before communication is established.
Clickrepair access code serial#
At this point you will NOT be communicating through the serial port. Baud rate and other communication settings are unimportant.ģ) Save the profile with a name such as ""EEG iCap".Ĥ) Start the BCS session. Select "EEG Compatible" as the encoder type.
Clickrepair access code software#
Then launch Case Catalyst.Ģ) In the BCS software create a Direct Connect profile to the COM port in use by iCap - the default is COM2. BCS is a plug-in for the Case Catalyst stenography software, so both applications are involved in the configuration.ġ) Launch iCap first, before launching Case Catalyst. These instructions refer specifically to BCS v8.01, but the configuration procedures are similar for other versions. "Direct Connect" enables you to select a serial port for communication instead of a modem. You will need to configure a "Direct Connect" profile in BCS. How do I configure the BCS software package to work with iCap, using the software serial port? You must set the iCap COM port to the name of the serial port you will be connecting the cable to, and iCap and the captioning software must be given the same settings for baud rate, parity, and start and stop bits. Use this option if you will be using iCap and your captioning software package on two different computers.
![clickrepair access code clickrepair access code](https://i.ytimg.com/vi/eYkxuewPoXQ/maxresdefault.jpg)
TCP/Telnet socket (now recommended for most users): The captioning software sends data to iCap through a TCP/IP port on the local machine.You will also need to create a matching configuration profile in your captioning software package - this process can vary somewhat depending on what package you use. You can select from these options by clicking Tools | Options from the iCap software's top toolbar. There are three basic options for getting the caption data you are writing from your software package to the iCap client.
![clickrepair access code clickrepair access code](https://i.ytimg.com/vi/fRF8cITB0kU/maxresdefault.jpg)
![clickrepair access code clickrepair access code](https://i.ytimg.com/vi/kNdjyNmjEuY/maxresdefault.jpg)
What are my options for connecting my captioning software package to the iCap client?